MIL-P-80104D
manufacture,
operation,
3.2.8 Environmental protection. During
the
service, transportation, or storage of the press, and its components materials
hazardous to the ecological system as prohibited by Federal, state, or local
statutes in effect on the date of the contract shall not be used or emitted.
3.2.9 Lubrication. Means shall be provided to ensure lubrication for all
moving parts. Each lubricant reservoir shall have means for determining fluid
level. All oil holes, grease fittings, and filler caps shall be accessible.
3.2.10 Interchangeability. To provide for replacement of worn parts, all
parts shall be manufactured to definite dimensions and tolerances that will
permit installation of replacement parts without modification of the part or
machine. All replacement parts shall be interchangeable with their respective
original parts, and fit/function with mating components.
3.3 Construction. The press shall be constructed of parts which are new,
without defects, and free of repairs. The structure shall withstand all
forces encountered during swaging operations to its maximum rating and
capacity without permanent distortion, or failure.
3.3.1 Castings and forgings. All castings and forgings shall be free of
defects, scale, and mismatching. No processes such as welding, peening, plug-
ging, or filling with solder or paste shall be used for reclaiming any defec-
tive part. Such processes may be used only for enhancing surface finish and
appearance.
3.3.2 Surfaces. All surfaces shall be clean and free of harmful or
extraneous materials. All edges shall be either rounded or beveled unless
sharpness is required to perform a necessary function. Except as otherwise
specified herein, the condition and finish of all surfaces shall be in
accordance with the manufacturer's commercial practice.
3.3.3 Welding, brazing, or soldering. Welding, brazing, or
soldering
shall be employed only where specified in the original design. None of these
operations shall be employed as a repair measure for any defective part.
3.3.4 Painting. Unless otherwise specified (see 6.2), the press shall be
painted in accordance with the manufacturer's commercial practice and color.
3.3.5 Threads. All threaded parts used on the press and its related
attachments and accessories shall conform to FED-STD-H28 and the applicable
"Detailed Standard" section referenced therein.
3.3.6 Electromagnetic interference control. When specified (see 6.2),
equipment furnished under this specification shall comply with MIL-STD-461.
The equipment and subsystem class and the emission and susceptibility
requirements shall be as specified.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business