MIL-P-0104D
REQUIREMENTS
3.
3.1 First article. When specified (see 6.2), one complete press shall be
subjected to first article inspection (see 6.4) in accordance with 4.4.
3.2 Design. The swaging press shall be new (not a prototype) and one of
the manufacturer's current production models capable of swaging metal fittings
on wire rope in accordance with the requirements herein. The press shall
include all components, parts, and features necessary to meet the performance
requirements specified herein. The press shall be of the scissor or alligator
type design with provisions in the jaws for installing dies for the swaging
process.
3.2.1 Measuring and indicating device calibration. Measuring and indicat-
ing devices shall be graduated in inch-pound (see 6.5.1) , metric (see 6.5.2) ,
or dual (inch-pound and metric) units as specified by the procuring activity
(See 6.2). Regardless of the measurement system used, all measuring and
indicating devices on the machine shall be graduated in the same system.
3.2.2 Reclaimed materials. The press may contain reclaimed materials to
the maximum extent possible provided such materials will not jeopardize the
intended use, performance, or-design life of the press. Reclaimed materials
shall have been collected or recovered from solid waste and reprocessed to
the above shall be interpret to mean that the use of used, rebuilt, or
remanufactured end products are allowed under this specification.
The press and its components that directly
3.2.3 Energy efficiency
consume energy in normal operation shall be designed and constructed for
energy efficiency in accordance with the developments available within the
industry.
located
3.2.4 Controls. All hydraulic operating controls shall be
convenient to the operator's work station.
3.2.5 Safety and health requirements. All parts, components, mechanisms,
and assemblies furnished on the press, whether or not specifically required
herein, shall conform with all requirements of 29 CFR 1910 and ANSI B11.2. If
a conflict arises between 29 CFR 1910 and B11.2, 29 CFR 1910 shall apply.
Additional safety and health requirements shall be as specified in detail (see
6.2). Covers, guards, or other safety devices normally furnished as standard
on the manufacturer's commercial press supplied to the commercial market shall
be provided for the point of operation and all other parts of the press that
present safety hazards. Additional guarding dependent on workpiece size and
configuration shall be provided when specified and fully described by the
procuring activity (see 6.2).
.
3.2.6 Mercury restriction. The press shall not contain mercury or
mercury compounds nor be exposed to free mercury during manufacture.
3.2.7 Asbestos restriction. Asbestos and materials containing asbestos
shall not be used on or in the press.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business