A-A-55015
h.
Additional performance features, if required (see 3.9.1).
i.
Specify and fully describe optional equipment, if required
(see 3.10.1).
Specify applicable repair parts, if required (see 3.11).
j.
k.
Specify and fully describe additional safety and health
requirements, if required (see 3.13.2).
1.
Data plates, if different fully describe (see 3.13.8).
m. Quality conformance inspection, when required (see 5.3).
n.
Inspection requirements, if different (see 5.3).
7.2 Part identification number (PIN). The following part
identification
numbering procedure is for Government purposes and does not constitute a
requirement for the contractor.
7.3 Source for documents referenced in this CID.
Federal Standards, FED-STD-376 and FED-STD-H28, are available from the
Standardization Documents Order Desk, Building 4D, 700 Robbins Avenue,
Philadelphia, PA 19120-5099.
OSHA, 29 CFR 1910 is available from the Superintendent of Documents, U. S.
Government Printing Office, Washington, DC 20402-0001.
ANSI B11.2 is available from the American National Standards Institute, ATTN:
Sales Dept., 1430 Broadway, New York, NY 10018-3363.
NFPA 79 is available from the National Fire Protection Association Inc.,
Batterymarch Park, Quincy, MA 02269-9101.
7.4 Preparing activity. This document'
at the
was prepared
Defense
Industrial Plant Equipment Center, 2163 Airways Blvd., Memphis, TN 38114-
5213, phone number, commercial 901-775-6247, DSN 638-6247.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business